How does Colorlight LED display software debug the display?
Colorlight has more professional technical means in the debugging of LED display software. Therefore, you can learn the debugging method from Colorlight when debugging the LED display.
Colorlight LED display software installation configuration:
①Display card driver installation: Put the display card driver CD into the CD-ROM drive and automatically enter the installation state, follow the prompts to complete the operation;
Note that DX9 is configured first and then the driver is installed; finally, the display card control program is configured.
②Video playback software: Install the special LED large-screen player and set up software or other control software; put the attached application software CD into the CD-ROM drive, copy or install it to the computer in the correct order.
③The full-color LED electronic display screen was successfully installed and debugged.
Colorlight LED display software debugging method:
1. The loading failure may be caused by the following reasons, please compare with your operation according to the listed items:
A. Make sure that the control system hardware has been powered on correctly. (+5V)
B. Check and confirm that the serial cable used to connect to the controller is a straight-through cable, not a crossover cable.
C. Check and confirm that the serial port cable is intact and there is no looseness or falling off at both ends.
D. Compare the control software of the LED display with the control card of your choice, and select the correct product model, correct transmission method, and correct The correct serial number, the correct baud rate, and the correct setting of the address bit and baud rate on the control system hardware according to the dial switch diagram provided in the software.
E. Check whether the jumper cap is loose or fall off; if the jumper cap is not loose, make sure the direction of the jumper cap is correct.
F. If it still fails to load after the above inspection and calibration, please use a multimeter to measure whether the serial port of the connected computer or control system hardware is damaged. Confirm whether it should be returned to the computer manufacturer or the control system hardware to be tested.
Other instructions:
① Check whether the wiring is correct, including the connection of the strong current cable, and whether the signal data line is connected correctly, mainly whether the input and output of the system receiving card are correct (there is a direction indication on the receiving card).
② Check that the system connection line is correct.
③Whether the computer software is successfully installed, including the installation of the display card driver and control software.
Matters needing attention:
①Follow the operation steps in the “User Manual”;
② Anti-humidity standard: the highest operating temperature, the relative humidity of the LED display should be less than 92
③Temperature standard requirements: working environment temperature -20°C≤: T≤80℃ storage environment temperature -40°C≤: T≤60℃
④The power supply voltage must meet the standard requirements: the power supply voltage of the LED display screen: 220V±10 Frequency: 50Hz±5
Ensure safe grounding, separate wiring of the ground wire and neutral wire, and keep the access voltage away from high-power electrical equipment.